Hirose Board-Level Connector 3D STEP/IGES Models
Provider:Hirose
Hirose serves 3D STEP/IGES models for board-to-board, FPC and RF connectors by part number via its product pages, for board-level and device twins.
At a glance
- Readiness
- L1 · Rigid-body ready
- Rationale
- Product pages and portals provide to-scale 3D models (STEP among them) and ECAD/CAx data, with extractable mass and collision geometry, hence L1; the assets are component exterior geometry and electrical-connectivity definitions, with no material parameters for EM, thermal or contact-mechanics simulation.
- Scale
- Covers the full line of board-to-board, FPC/FFC, RF and circular connectors; product-page CAD/3D sections serve STEP/IGES models by part number, largely distributed via TraceParts. (The part-number lookup and STEP/IGES download in the product-page CAD/3D section follow Hirose’s official product-page structure (largely via TraceParts); no single-vendor model count is published, so coverage is stated by product line and page. Checked 2026-11-01.)
- License
- Proprietary but free — 3D CAD data are free for product design; the intellectual property belongs to Hirose and may not be redistributed or used outside design. The models are exterior geometry; current rating and contact resistance must come from the official technical datasheets.
- Access
- Open
- Formats
- step · iges · other · dict
- Runtimes
- other
- Physics properties
- Collision geometryMass / inertiaElectrical
- Domain
- Electromagnetics / Power · Solid / Structure
- Published
- 2026-11-01
- Updated
- 2026-11-06
Why it is listed
Hirose is a Japanese connector specialist whose board-to-board, FPC/FFC and RF connectors appear on countless electronics products. For a board-level or device twin, its connector geometry is what the mechanical model needs, served from the vendor’s own product pages.
Readiness assessment
Hirose product pages serve 3D STEP and IGES models per connector part number, giving rigid-body geometry with extractable mass and collision shells — that is L1. The assets are connector housing geometry; they carry no material parameters for EM or thermal simulation, and current/contact ratings must come from the datasheet.
Practical notes
On a product page, open the CAD/3D section and download the STEP or IGES model for the specific connector. For a board layout, match the footprint with the mechanical model so the stack-up is correct. Current and contact ratings are in the product drawing, not the mesh.
Disclaimer: license and usage terms follow the official source — verify them yourself before use. This site indexes and links only; it does not host or mirror any asset file.
License and usage terms are those of the official source — verify before use. No asset file is hosted or mirrored on this site.